FJD AT2 vs Trimble EZ-Steer: an honest comparison from a dealer who sells one of them
Deep Sand Tech sells FJDynamics systems, so read this knowing that. Trimble EZ-Steer has been steering tractors for a long time and PTx Trimble still sells it, so it is a fair system to measure against. Every EZ-Steer and EZ-Pilot Pro fact below is quoted from PTx Trimble’s own product pages as of November 18, 2026, with nothing added.
Side by side
Left column is the FJD AT2 family we sell. Right column is PTx Trimble, quoted from its EZ-Steer and EZ-Pilot Pro product pages on November 18, 2026. Where their pages do not say, we say "not stated" rather than guess.
| FJD AT2 (what we sell) | PTx Trimble (their words) | |
|---|---|---|
| Steering | Motorized steering wheel on the column (AT2 family), hydraulic valve kit (AH2) or steer-ready kit (AS2) for tractors that came guidance-ready from the factory. Wheel angle sensor optional on most tractors. | EZ-Steer turns "the steering wheel for you by combining a friction wheel and motor." It "locks away from the steering wheel when not in use and quickly disengages when you manually turn the steering wheel." |
| What it is built for | Tillage and spraying on WAAS, and planting, strip-till, bedding and digging on RTK. | EZ-Steer: "easy to install and ideal for low-accuracy operations." EZ-Pilot Pro: "high-accuracy guidance across a wide variety of machines for all farming operations." |
| Correction signal | RTK over cellular (GEODNET network), your own radio base station, or StarNav satellite correction. Also runs WAAS when nothing else is available. | Both pages list "Trimble RTX Correction Services" as a related product: "real-time, high accuracy corrections in the field via satellite or internet." |
| Stated accuracy | About 2.5 cm (one inch) pass-to-pass with RTK under normal conditions, per FJD. The same lines year after year, because RTK is repeatable. | No accuracy figure is given on the EZ-Steer or EZ-Pilot Pro pages we checked. |
| Display | Dedicated in-cab display: 10-inch tablet on the AT2 Lite, 10.1-inch terminal on the AT2, 12.1-inch on the AT2 Max, 16-inch on the AT2 Ultra. Coverage map, field boundaries, lines and jobs stored on the display. | EZ-Steer works "with guidance from any PTx Trimble display," used "in combination with a PTx Trimble display and guidance controller." GFX displays are the related product listed. |
| Headland turns | Automatic U-turn on the AT2, AT2 Max and AT2 Ultra; the tractor turns and picks up the next pass on its own. | "NextSwath 2 end-of-row turn technology automatically guides the vehicle along the best possible path for turning around and approaching the next crop row or swath." On the EZ-Pilot Pro page it is "available when used with the NAV-900 guidance controller." |
| Slopes and rough ground | Terrain compensation: the system compensates for vehicle tilt on sloping or uneven ground. | EZ-Steer: "T2 sensors calculate the actual position of the vehicle to help minimize skips and overlaps in areas with rolling terrain, slopes and rough ground." EZ-Pilot Pro uses T3. |
| Machines | Any brand, any age. Motor system for tractors with a steering column, hydraulic and steer-ready systems for the rest, plus combines, sprayers, swathers and articulated tractors. | EZ-Steer: "more than 1,200 vehicle models – old and new." EZ-Pilot Pro: "mechanical front-wheel drive and four-wheel drive tractors and combines." |
| Implements | ISOBUS implement control, section control and rate control from the same display on the AT2, AT2 Max and AT2 Ultra. Path Assist implement steering available. | Not mentioned on the EZ-Steer or EZ-Pilot Pro pages. It depends on the PTx Trimble display the steering is paired with. |
| Warranty | Two years on the main parts, and a one-year buy-back guarantee. | Not stated on the pages we checked. |
| Support | Deep Sand Tech. Phone and text 8 AM to 8 PM daily, remote login to your display, and a dealer that runs the same kits on its own farm. | Through the dealer network: "Connect with a local dealer." |
| What you pay to run it | First year of network RTK included in our quotes. After that, a yearly network RTK renewal, or no network fee at all if you run your own base station. Cellular SIM if you use the network. No software subscription to keep steering. | Not stated on the pages we checked. Ask the dealer what the correction service runs per year. |
| Price | We do not publish prices. Call for a quote on the kit and on what it costs to run. | Not shown on the pages we checked. |
The first question: what is already in the cab
EZ-Steer is not a whole guidance system. PTx Trimble describes it as a friction wheel and motor that steers "with guidance from any PTx Trimble display," used with a PTx Trimble display and guidance controller. If that display is already in the tractor, EZ-Steer is the piece that turns the wheel for it.
The FJD AT2 comes at it the other way. The receiver on the roof, the display in the cab and the motor on the column are one system, so a tractor that has never had guidance on it goes from bare to steering itself with one kit.
Friction wheel or column motor
EZ-Steer presses a friction wheel against the steering wheel that is already on the tractor, and per PTx Trimble it "locks away from the steering wheel when not in use." The FJD AT2 puts a motorized steering wheel on the column in place of the stock wheel. Both leave the hydraulics alone, and both let you grab the wheel and take over.
The difference that decides it: how straight
GPS by itself puts a tractor within a few feet. WAAS, the free correction, gets that to a few inches, and the position drifts through the day. RTK uses a base station or a network of them within a few dozen miles to correct the receiver in real time, and that gets you to about an inch, repeatable, on the same lines next year.
PTx Trimble calls EZ-Steer "ideal for low-accuracy operations" and points high-accuracy work to the EZ-Pilot Pro. The FJD AT2 runs RTK off the GEODNET network, off your own base station, or off StarNav. For tillage and spraying, several inches is fine. For planting, strip-till, bedding, digging peanuts, or anything where this year's pass has to land on last year's, you need RTK and steering built for it.
FJD AT2 on RTK, on older tractors
What the one-inch line looks like from the cab.
What the FJD kit puts on the tractor


Our honest take
- Pick EZ-Steer if a PTx Trimble display is already in the cab, the job is tillage, mowing or broadcast spraying, and a few inches is fine.
- Pick the EZ-Pilot Pro if you want to stay with Trimble and need high-accuracy steering, and you have a Trimble dealer close by.
- Pick the FJD AT2 if the tractor is bare, you plant or dig on last year's rows, you run sections or a rate controller, or you want a dealer you can call at 7 PM who will log into your screen.
- Either way, fix the steering slop first. Every system steers to the line; a loose front end is what makes any of them hunt.
- Make, model and year of the tractor
- What you will run it on: planter, drill, sprayer, digger
- Whether you need sections or rate control
- Your farm's location so we check RTK coverage first
Trimble, EZ-Steer and EZ-Pilot are trademarks of their owners. Deep Sand Technology is an FJDynamics dealer and is not affiliated with Trimble or PTx Trimble. See also FJD AT2 vs Wheelman.
Common questions
Is Trimble EZ-Steer accurate enough to plant with?
PTx Trimble’s own page calls EZ-Steer "ideal for low-accuracy operations" and does not give an accuracy figure. For high-accuracy work PTx Trimble points to the EZ-Pilot Pro. What either one holds in the field comes down to the correction the display and guidance controller are running, so ask the Trimble dealer what that is before you plant on it.
What is the difference between EZ-Steer and EZ-Pilot Pro?
Per PTx Trimble, EZ-Steer combines "a friction wheel and motor" and is "ideal for low-accuracy operations." The EZ-Pilot Pro "offers high-accuracy guidance across a wide variety of machines," stays engaged in reverse for up to 15 seconds, and uses T3 terrain compensation where EZ-Steer uses T2.
Is the FJD AT2 really within an inch?
With an RTK correction, yes: FJD states about 2.5 cm pass-to-pass under normal conditions, which is right at one inch, and that is what our customers see on planters and peanut diggers. Without RTK, on WAAS alone, the AT2 is in the same several-inch range as any WAAS system. The accuracy is in the correction, not the brand.
Does EZ-Steer work with an FJD display, or the FJD motor with a Trimble display?
No. PTx Trimble says EZ-Steer works "with guidance from any PTx Trimble display," and the FJD steering runs from the FJD display. They are two separate systems. The FJD AT2 has its own display, so it does not need a Trimble one in the cab.
Which one is cheaper?
We do not publish prices on this site, and PTx Trimble’s pages do not show prices either. Price both the same way: the display, the receiver or guidance controller, the steering, and what the correction costs each year. Call and we will quote the FJD side, the kit and what it costs to run.
Why would someone pick EZ-Steer over FJD?
Because the Trimble display is already in the cab and there is a Trimble dealer down the road. If the work is tillage or spraying and the display is paid for, adding EZ-Steer to it is a fair choice. If you are starting with a bare tractor, or you plant, strip-till or dig on last year’s rows, look at the AT2.
More on auto steer
Auto steer for tractors · How auto steer works · Is my tractor steer-ready? · Auto steer for older tractors · Hydraulic auto steer (AH2) · AS2 steer-ready · Compare FJD auto steer systems · Tractor GPS systems · RTK vs WAAS · FJD AT2 vs Wheelman · All buyer guides · Autosteer solutions across the United States

